Lenovo NeXtScale n1200, Installation And Service Manual

Page: 57 / 878

Step 2. Separate the number into pairs of hexadecimal characters (for example, 5C:F3:FC:5E:AA:D0).
Step 3. Separate the first six and last six hexadecimal characters.
Step 4. Add “FF” and “FE” in the middle of the 12 characters (for example, 5C F3 FC FF FE 5E AA D0).
Step 5. Convert the first pair of hexadecimal characters to binary (for example, 5=0101, C=1100, which
results in 01011100 F3 FC FF FE 5E AA D0).
Step 6. Flip the 7th binary character from left (0 to 1 or 1 to 0), which results in 01011110 F3 FF FE 5E AA
D0.
Step 7. Convert the binary back to hexadecimal (for example, 5E F3FCFFFE5EAAD0).
Obtaining the IP address for the IMM2.1
Use this information to obtain the IP address for the IMM2.1.
To access the web interface to use the remote presence feature, you need the IP address or host name of
the IMM2.1. You can obtain the IMM2.1 IP address through the Setup utility and you can obtain the IMM2.1
host name from the IMM2.1 network access tag. The server comes with a default IP address for the IMM2.1
of 192.168.70.125.
To obtain the IP address, complete the following steps:
Step 1. Turn off the server.
Note: Approximately 5 to 10 seconds after the server is connected to power, the power-control
button becomes active.
Step 2. When the prompt
<F1> Setup
is displayed, press
F1
. (This prompt is displayed on the screen for
only a few seconds. You must press
F1
quickly.) If you have set both a power-on password and an
administrator password, you must type the administrator password to access the full Setup utility
menu.
Step 3. From the Setup utility main menu, select System Settings .
Step 4. On the next screen, select Integrated Management Module .
Step 5. On the next screen, select Network Configuration .
Step 6. Find the IP address and write it down.
Step 7. Exit from the Setup utility.
Logging on to the web interface
Use this information to log on to the web interface.
To log on to the IMM2.1 web interface, complete the following steps:
Step 1. On a system that is connected to the server, open a web browser. In the Address or URL field,
type the IP address or host name of the IMM2.1 to which you want to connect.
Note: If you are logging on to the IMM2.1 for the first time after installation, the IMM2.1 defaults to
DHCP. If a DHCP host is not available, the IMM2.1 assigns a static IP address of 192.168.70.125.
TheIMM2.1 network access tag provides the default host name of the IMM2.1 and does not require
you to start the server.
Step 2. On the Login page, type the user name and password. If you are using the IMM2.1 for the first time,
you can obtain the user name and password from your system administrator. All login attempts are
documented in the system-event log.
Chapter 3
.
Configuration information and instructions
43