Lenovo ideapad 510S, Hardware Maintenance Manual

Page: 54 / 69

Step 13. Disconnect the camera data cable from the connector in the USB board.
Step 14. The camera is stick to the USB board by adhesive bandage. Separate the camera from the USB
board.
Step 15. To install the new USB board:
a. Align the new USB board with the camera, and then stick it to the camera using adhesive
bandage.
b. Secure the camera and USB board assembly to the pull down assembly cover with two screws.
c. Connect the camera cable to the connector in the USB board.
d. Place the pull down assembly bracket into position.
Step 16. Reattach the pull down assembly, motherboard, EMI cover, stand holder, rear cover, and stand
base.
Replacing the LCD panel module
Note: Turn off the computer and wait 3 to 5 minutes to let it cool down before removing the cover.
Note: It may be helpful to place the computer face-down on a soft flat surface for this procedure. Lenovo
recommends that you use a blanket, towel, or other soft cloth to protect the computer screen from scratches
or other damage.
To replace the LCD panel module:
Step 1. Remove any media from the drives, shut down the operating system, and turn off the computer
and all attached devices.
Step 2. Unplug all power cords from electrical outlets.
48
ideacentre All-In-One 510S Computer Hardware Maintenance Manual