Lenovo HX1310, Installation And Service Manual

Page: 143 / 1002

Removing a thermal kit (hot-swap fan)
Use this information to remove a thermal kit (hot-swap fan).
Attention: It is not necessary to disconnect the power when removing the hot-swap fan. To ensure proper
server operation, replace a failed hot-swap fan within 30 seconds.
To remove a hot-swap-fan, complete the following steps:
Step 1. Read the safety information that begins on “Safety” on page v and “Installation guidelines” on
page 100.
Step 2. Remove the cover (see “Removing the cover” on page 104).
Step 3. Grasp the orange fan tabs on both ends of the fan and slowly lift it out of the chassis.
Fan 8
Fan connector on
the system board
Fan tabs
Figure 53. Fan removal
If you are instructed to return the fan, follow all of the packaging instructions, and use any packaging
materials for shipping that are supplied to you.
Replacing a thermal kit (hot-swap fan)
Use this information to replace a thermal kit (hot-swap fan).
The server comes standard with five dual-motor hot-swap cooling fans. When there is one microprocessor
installed, install fan 1, 2, 3, 5, and 7 for proper cooling.
Attention: To ensure proper operation, replace a failed hot-swap fan within 30 seconds.
To replace a hot-swap fan, complete the following steps:
Chapter 5
.
Removing and replacing components
129