Lenovo HR650X V2, User Manual

Page: 65 / 192

Remove the front 3.5-inch drive backplane
Use this information to remove the front 3.5-inch drive backplane.
About this task
Attention:
• Read “Installation Guidelines” on page 25 to ensure that you work safely.
• Power off the server and disconnect all power cords for this task.
• Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-
sensitive components in their static-protective packages until installation, and handling these devices with
an electrostatic-discharge wrist strap or other grounding system.
Procedure
Step 1. Prepare your server.
a. Remove the top cover. See “Remove the top cover” on page 30.
b. Remove the air baffle. See “Remove the air baffle” on page 41.
c. Remove the system fan cage for easier operation. See “Remove a system fan” on page 44.
d. Remove all the installed drives and fillers (if any) from the drive bays. See “Remove a hot-swap
drive” on page 28.
Step 2. Lift the release tabs and rotate the backplane backward slightly to release it from the two pins on
the chassis.
Note: Depending on the specific type, your backplane might look different from the illustration.
Figure 35. 3.5-inch drive backplane removal
a. Pull out the plungers and slightly slide the backplane to the side as shown.
b. Rotate the backplane down to release it from the four hooks on the chassis. Then, carefully lift
the backplane out of the chassis.
Step 3. Record the cable connections on the backplane and then disconnect all cables from the
backplane.
Chapter 4
.
Hardware replacement procedures
57