• “Install a PCIe adapter” on page 80
• “Install a riser card” on page 83
• “Install the rear 2.5-inch drive cage” on page 62
• “Install the rear 3.5-inch drive cage” on page 67
• “Install the OCP 3.0 Ethernet adapter” on page 78
2. Properly route and secure the cables in the server.
3. Install the air baffle if you have removed it. See “Install the air baffle” on page 42.
4. Install the top cover. See “Install the top cover” on page 32.
5. Push the power supplies into the bays until they click into place.
6. Connect power cords to the server and turn on the server.
7. Update the server with the latest RAID firmware.
8. Optionally, enable Secure Boot.
Complete the parts replacement
Use this information to complete the parts replacement.
To complete the parts replacement, do the following:
1. Ensure that all components have been reassembled correctly and that no tools or loose screws are left
inside your server.
2. Properly route and secure the cables in the server.
3. If you have removed the top cover, reinstall it. See “Install the top cover” on page 32.
4. Reconnect external cables and power cords to the server.
Attention:
To avoid component damage, connect the power cords last.
5. Update the server configuration if necessary.
.
Hardware replacement procedures
113
Summary of Contents for HR650X V2
