Step 3. Install the OCP 3.0 Ethernet adapter.
Notes:
• Ensure that the Ethernet adapter is fully seated and the thumbscrew is securely tightened.
Otherwise, the OCP 3.0 Ethernet adapter will not get full connection and may not function.
• If there is an OCP 3.0 Ethernet adapter installed, when the system is powered off but still
plugged in to AC power, system fans will continue to spin at a much lower speed. This is the
system design to provide proper cooling for the OCP 3.0 Ethernet adapter.
Figure 43. OCP 3.0 Ethernet adapter installation
a. Push the OCP 3.0 Ethernet adapter by its handle on the left until it is fully inserted into the
connector on the system board.
b. Fully tighten the thumbscrew to secure the adapter.
After you finish
Complete the parts replacement. See “Complete the parts replacement” on page 110.
PCIe adapter replacement
Use this information to remove and install a PCIe adapter.
The PCIe adapter can be an Ethernet adapter, a host bus adapter (HBA), a PCIe RAID adapter, a PCIe
interposer adapter, a PCIe solid-state drive, a PCIe GPU, and any other supported PCIe adapter.
Notes:
• Depending on the specific type, the PCIe adapter might look different from the illustrations in this topic.
70
HR630X V2 User Guide
Summary of Contents for HR630X V2
