Lenovo HR630X V2, User Manual

Page: 73 / 134

Figure 37. M.2 retainer adjustment
Step 1. Press both sides of the retainers.
Step 2. Move the retainer forward until it is in the large opening of the keyhole.
Step 3. Take the retainer out of the keyhole.
Step 4. Insert the retainer into the correct keyhole into which the retainer should be installed to
accommodate the particular size of the M.2 drive you wish to install.
Step 5. Press both sides of the retainer.
Step 6. Slide the retainer backwards until it is seated in place.
Install the M.2 adapter and M.2 drive
Use this information to install the M.2 adapter and M.2 drive.
About this task
Attention:
• Read “Installation Guidelines” on page 27 to ensure that you work safely.
• Power off the server and disconnect all power cords for this task.
• Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-
sensitive components in their static-protective packages until installation, and handling these devices with
an electrostatic-discharge wrist strap or other grounding system.
Procedure
Step 1. Touch the static-protective package that contains the M.2 adapter and M.2 drive to any unpainted
surface on the outside of the server. Then, take the M.2 adapter and M.2 drive out of the package
and place them on a static-protective surface.
Notes:
• The M.2 adapter module is shipped with a loose screw, but the screw is not necessarily used for
the installation.
• The M.2 adapter you want to install might be different from the following illustrations, but the
installation method is the same.
Step 2. Adjust the retainer on the M.2 adapter to accommodate the particular size of the M.2 drive you wish
to install. See “Adjust the retainer on the M.2 adapter” on page 64.
Chapter 4
.
Hardware replacement procedures
65