Lenovo BladeCenter HS22, Installation And User Manual

Page: 52 / 96

To remove a CIOv expansion card, complete the following steps:
Step 1. Before you begin, read “Safety” on page iii and “Installation guidelines” on page 17.
Step 2. If the blade server is installed in a BladeCenter unit, remove it (see “Removing the blade server
from the BladeCenter unit” on page 19 for instructions).
Step 3. Carefully lay the blade server on a flat, static-protective surface.
Step 4. Open the blade server cover (see “Removing the blade server cover” on page 20 for instructions).
Step 5. Touch the static-protective package that contains the expansion card to any unpainted metal
surface on the BladeCenter unit or any unpainted metal surface on any other grounded rack
component; then, remove the expansion card from the package.
Step 6. Locate the CIOv expansion connector (see “Blade server connectors” on page 14).
Step 7. Using your fingers, move the retaining clips away from the CIOv card; then, lift the card out of
the connector.
Installing a storage interface card
Use this information to install a storage interface card in the blade server.
Note: This section does not apply to the IBM WebSphere DataPower Integration Blade XI50B Type 4195
appliance.
The storage interface card controls the SAS hot-swap storage drives. The following illustrations and
installation instructions shows how to install a ServeRAID-MR10ie controller into the CIOv expansion
connector of the blade server. The illustrations and installation instructions are similar for other CIOv
storage interface cards.
42
BladeCenter HS22 Blade ServerInstallation and User's Guide