Lenovo 82K8002YGE-FL, Hardware Maintenance Manual, Page: 55 / 68

Figure 34. Take out the EDP cable and then remove the LCD module
Remove the upper case (with keyboard and touchpad)
Make sure the following FRUs (CRUs) have been removed.
“Remove the lower case” on page 30
“Remove the solid-state drive (SSD) module” on page 31
“Remove the battery pack” on page 33
“Remove the Wi-Fi card” on page 33
“Remove the solid-state drive (SSD) mylar” on page 34
“Remove the DC-in bracket” on page 35
“Remove the memory module mylar” on page 35
“Remove the memory module” on page 36
“Remove the heat sink” on page 37
“Remove the fans” on page 38
“Remove the solid-state drive (SSD) bracket” on page 38
“Remove the USB board module” on page 39
“Remove the CMOS battery” on page 41
“Remove the speakers” on page 41
“Remove the touchpad cable” on page 42
“Remove the system board” on page 43
“Remove the fingerprint board cable” on page 44
“Remove the fingerprint board and Cu Foil mylar” on page 45
“Remove the strip cover” on page 46
“Remove the LCD module” on page 47
Go to
https://support.lenovo.com/partslookup
to look up the Lenovo part number of the following replacement
part:
Upper case (with keyboard and touchpad)
Chapter 4
.
Removing a FRU or CRU
49