Lenovo 7D2F, Maintenance Manual

Page: 63 / 188

To install a 2.5-inch drive, complete the following steps:
Step 1. If new drives are to be added, see “Install a 2.5-inch drive” in
ThinkSystem SR850P Setup Guide
to
determine available drive bays to the new drives.
Step 2. Gently rotate the release latch away to unlock the drive handle.
Step 3. Slide the drive into the drive bay, and push it until it stops.
Figure 41. Drive installation
Step 4. Rotate the drive-tray handle back to the locked position.
After installing the 2.5-inch hot-swap drive, check the drive status LED to verify if the drive is operating
correctly:
• If the yellow LED is lit continuously, it is malfunctioning and must be replaced.
• If the green LED is flashing, the drive is functioning.
Note:
If the server is configured for RAID operation through a ThinkSystem RAID adapter, you might have to
reconfigure your disk arrays after you install drives. See the ThinkSystem RAID adapter documentation for
additional information about RAID operation and complete instructions for using ThinkSystem RAID
adapters.
CMOS battery (CR2032) replacement
Use this procedure to remove or install the CMOS battery (CR2032).
Remove the CMOS battery (CR2032)
Use this procedure to remove the CMOS battery.
The following notes describe information that you must consider when replacing the battery:
• Lenovo has designed this product with your safety in mind. The lithium battery must be handled correctly
to avoid possible danger. If you replace the battery, you must adhere to the following instructions.
• If you replace the original lithium battery with a heavy-metal battery or a battery with heavy-metal
components, be aware of the following environmental consideration. Batteries and accumulators that
contain heavy metals must not be disposed of with normal domestic waste. They will be taken back free
of charge by the manufacturer, distributor, or representative, to be recycled or disposed of in a proper
manner.
• After you replace the battery, you must reconfigure the server and reset the system date and time.
S002
Chapter 3
.
Hardware replacement procedures
55