26
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
1. Place the rear log (A) as shown in Figure 42
.
Position the 2 holes
on the bottom of the log over the corresponding locating pins (#1 &
#2) and against the log support bracket. See
Figures 41 and 42
for
pin and rear bracket locations.
2. Place the left middle log (B) as shown in Figure 43
.
Position the hole
on the bottom of log B over the corresponding locating pin on Log A.
5. Place the right middle log (C) as shown in Figure 46
.
Position log
C behind Log E and resting on the "flat" on Log A.
3. Place the left front log (D) as shown in Figure 44
.
Position the hole
on the bottom of log D over pin# 3.
4. Place the right front log (E) as shown in Figure 45
.
Position the hole
on the bottom of log E over pins #4 and # 5.
6. Ember Placement -
Separate the Embers (rockwool) into pieces
about the size of a quarter (see
Figure 41)
. Keep the pieces fluffed
up, not matted. Distribute these pieces over the surface of the burner,
as shown in
Figure 47
. Do not use more than is necessary.
Ensure
that the main burner ports remain uncovered by the ember material
(see
Figure 41)
.
A
Figure 42 - Install Rear Log (A)
B
A
Figure 43 - Install Left Middle Log (B)
Figure 46 - Install Right Middle Log (C)
Figure 44 - Install Left Front Log (D)
Figure 45 - Install Right Front Log (E)
1
2
Figure 47 - Ember Placement
DO NOT place ember material directly
over the ember burner ports.
4
5
D
D
C
E
A
E