Lenel m3000, Installation Manual, Page: 66 / 118

Reader Processing Boards
66
M3000 Installation Guide
Setting the DIP Switches
Set the DIP switches as described in the table below before installing and wiring the 8RP board.
Powering Two 8RP Boards
To ensure proper function when using two 8RP Boards in the M3000 controller, the second 8RP
Board should be wired directly to the Power Communication board as shown in the figure below.
Reader Technology
Reader Technology SW 1-1 SW 1-2 SW 1-3 SW 1-4
Magstripe - Supervised F/2F ON ON
Magstripe - F/2F ON ON ON
= OFF
8RP Board Address Settings
Board Type
SW 1- SW 2-
5 6 7 8 1 2 3 4 5 6 7 8
Board 1
a
a. The first eight (8) readers out of 16.
Does not
apply. ON ON ON ON ON
Board 2
b
b. The second eight (8) readers out of 16.
ON ON ON ON ON
= OFF