Lenel m3000, Installation Manual, Page: 104 / 118

Troubleshooting and Maintenance
104
M3000 Installation Guide
Resolution :
1.
Short the Restore Defaults pins (JP4) until DS3 turns on.
2.
The controller is now offline from the host and the factory defaults have been restored. The
factory defaults are as follows:
•
Host Server/Type: OnGuard
•
Primary Connection Type: Ethernet
•
IP Address: 192.168.6.6
•
Mask: 255.255.255.0
•
Gateway: 192.168.6.1
3.
If necessary, reconfigure the controller, as described in Controller Setup Overview on page 83 .
Problem: The network controller does not connect.
Resolution :
1.
Verify your network settings:
•
Host IP address
•
Controller IP address and controller address
•
Network mask
•
Gateway IP
•
DHCP server
2.
Check the connectivity using the Ping Host option in the Integrated Configuration Tool (ICT).
a.
From the Controller Information menu of the ICT, select the Information tab .
b.
From the Selection Items drop-down list, select Ping Host .
Successful ping Example:
Diagnostic LED Display
The CPU board LEDs are used for displaying error codes.
PXNplus CPU Board LED Fault Conditions
DS1 DS2 DS3 DS4 DS5 DS6 DS7 DS8 Resolution or Definition
Operation state