Lenel LNL-3300-M5, Installation Manual

Page: 41 / 184

M Series Installation Guide
revision 7 —
41
7 Jumpers and Switches
7.1 J4 Termination Jumper
Install jumper J4 to terminate the 2-wire RS485 communication bus on TB2. Only terminate the units at
each end of the communication bus. For more information, refer to
Communication Wiring on page 45.
7.2 DIP Switches
Use the four S1 DIP switches to configure the operating mode for the LNL-3300-M5. DIP switches are read
on power-up (except where noted).
All other switch settings are unassigned and reserved for future use. X = Not applicable/not used.
Notes: In factory/OEM modes, the downloaded configuration/database is not saved to flash memory.
The following are factory default communication parameters:
Network: Static IP Address: 192.168.0.251
Gateway Mask: 255.255.255.0
Communication Address: 0
Primary Host Port: IP server, no data security, Port 3001
Alternate Host Port: Disabled
7.3 Reset Switch
Press the S2 switch to reboot the LNL-3300-M5.
1 2 3 4 Definition
OFF OFF X OFF Normal operating mode.
ON X X X After initialization, enable default User Name (admin) and Pass-
word (password). The switch reads on the fly. No need to reboot.
OFF ON X OFF Use factory default communication parameters. See below.
ON ON X OFF Use OEM default communication parameters. Contact the system
manufacturer for details. For more information, refer to
Bulk Erase
Function on page 51.
X X ON X Disable TLS secure link. Switch only reads when logging on.
ON ON OFF OFF Bulk Erase prompt mode at power up. For more information, refer
to
Bulk Erase Function on page 51.