Lenel DirecDoor, Installation Manual

Page: 77 / 90

DirecDoor Installation Guide
77
CHAPTER 11
Regulatory Information
CE (European) and FCC Compliance
As of January 1, 1996, all new European Union member installations MUST be CE compliant.
To make the DirecDoor installation CE and FCC compliant, the following conditions must be met:
•
All cables connected to the DirecDoor must be shielded with shield terminated as shown in
figure Typical Installation Using Shielded Cable/Drain Wire on page 78 . Use #8-32 SEMS
screws provided.
•
The DirecDoor enclosure must be connected to the nearest earth ground. Refer to figure Wiring
Earth Ground on page 26 .
•
Before connecting the network cable to connector J10, loop the cable through Ferrite provided as
shown in figure
Installing Ferrite on page 78 .
Note:
Ferrite must be installed inside of the enclosure.