LEMKEN Thorit 9 K, Operating Instructions Manual

Page: 32 / 49

30
9 SHEARBOLT DEVICE
Each tine (H0) and disc carrier is fitted with a shearbolt (H1) which will protect
cultivator, tines, the share points (H2) and discs against overload.
Replace sheared bolt (H1) as follows:
a) Raise cultivator a few cm.
b) Remove all remains of the shearbolt.
c) Swing tine and/or disc carrier back into position.
d) Fit new shearbolt into hole concerned and tighten carefully.
Only shearbolts according to the schedule below should be used. Otherwise
there is a serious risk of damage to frame, tine or disc carrier or a premature
failure may be experienced.
• Read and adhere to the General Safety Instructions as well
as to the Instructions „Maintenance“!
• When changing shearbolts, use suitable tools, only!
Tines Disc carrier with shearbolt
device
Thorit
301 7342
M12 x 65 B = 15/8.8
301 3240
M10 x 45 B = 10/8.8
Thorit Ü
301 3391
M12 x 60 B = 15/10.9
301 3240
M10 x 45 B = 10/8.8