Step 2
With the
8 mm wrench
and
4 mm allen key
, use 2 bolts
(and washers) to attach the carrier to the bike. When doing
so, make sure to use the third hole from the top, and tighten
the bolts just a little for now. Do this same for all bolts in the
next steps, you will tighten all of them fully once the carrier is
installed in the correct position.
Step 3
Before you proceed, make sure that you use
the carrier stays on the correct side. This is
because the frontlight will be attached to the
right side of the carrier (when viewing from the
front, such as on the picture). So make sure
the stay with the part circled in red is used on
this right side.
