Leitronic AG EA-8-WRL868, Use Instruction, Page: 4 / 40

4
2. SAFETY INSTRUCTION
2.1 Approval
According to the R&TTE Directive 1999/5/EC of 09.March 1999
Manufacturer’s Name: Leitronic AG
Manufacturer’s Address: Engeloostrasse 16, CH-5621 Zufikon, Switzerland
declares that the product
Product Name: EasyAlarm
Model Number: EA-8-868
conforms to the following product specifications:
Safety (R&TTE, Article 3.1a): EN60950: 1992+A1+A2+A3+A4
EMC (R&TTE, Article 3.1b): EN 50081-1, 1992
EN 50082-1, 1997 Class B
Radio spectrum: EN 300 220
ETS 300
Telephone: CTR21 as specified in Council Decision 98/482/EC
Supplementary Information
The product herewith complies with the requirements of the following Directives and carries the CE marking
accordingly:
the EMC directive 89/336/EWG
the Low Voltage Directive 93/68/EEC
Zufikon, 1. April 2010 Silvan Tognella
2.2 Telephone connection
EasyAlarm®
is designed to connect to an analogue telephone line. This connection should remain in service
for at least one hour after a mains power. These are:

analogue PSTN

analogue port of an ISDN terminal (ISDN-NT has to be reprogrammed for emergency operation at the
ab-port)

analogue port of a private exchange using UPS (Uninterruptible power supply 1h buffering)

GSM Interface with approval, i.e. EA-GSM-Interface from Leitronic.
Not suitable:

Voip or cable modem, as in case of power loss it is not functional!
The voltage of the telephone network is defined in EN 41003. It is higher than 40 V and therefore please
beware for electrical hazard and disconnect
2.3 Wireless sensors
868.65MHz => permit according to description of wireless-sensors.
2.4 Power supply
A transformer according to the safety regulation EN60950 provides power supply, or by 9V battery. It is
located on the rear side oft the device.
2.5 Safety notes

Do not bring the device into contact with water.

Do not open the device (exception: opening the battery cover for exchange).

Replace the 9V-battery as soon as the announcement “battery error” is announced.

Please note: The telephone cord must be disconnected before opening the battery compartment
because otherwise you can get in contact with the telecommunication voltage!

Check alarm functions and start a test-call , before the system is put in service.

Check from time to time the range of the emergency button according to section 5.5.5

In case that
EasyAlarm®
is used to monitor children, the supervising person must be in a suitable
distance to take immediate care for the child.
EasyAlarm®
does not replace personal supervision!

The same applies to handicapped persons,
EasyAlarm®
is not a substitute of a personal care taker!

Radio transmission between the sensor and
EasyAlarm®
can be disturbed through another systems

An alarm by telephone is only successful if the alarmed party takes care of the following points:

Alarm must not be answered by an answering machine or equal equipment

Mobile phones can be out of range (e.g. underground car park, shielded rooms, remote areas..)

Take care of the charging condition of the mobile phone

Loud noise can prevent you from hearing the ringer

All the electrical connections have to be potential free. Observe the regulation according to EN60950.