Leitronic AG EA-8-WRL868, Use Instruction, Page: 27 / 40

27
9. SPECIAL PROGRAMMING
Important notes:

All parameters remain stored even if
EasyAlarm
®
is switched off or without battery. Therefore
reprogramming is only essential if parameters have to be changed.

Programming mode can be locked to secure against unintended programming during operation (

section 5.4.1). If lock is activated, the announcement „programming inactive: PIN“ will be
announced if
function switch is shifted to PROG.

Attention: Changing these parameters below does influence the operating mode. Therefore only
necessary parameters should be changed. Please test behaviour before putting the unit back into
operation!

A programming error can be corrected by repeating the programming steps accordingly.
9.1 Factory settings (Default-Values)
EasyAlarm
®
can be reset to default values as follows:
OFF ON
PROG
Keep
3
and
#
pressed
simultaneously
OFF ON
PROG
Release
keys
OFF ON
PROG
9.2 Alarm repetition
An alarm is triggered, as soon as the alarm criteria is fulfilled and the waiting period has expired. In some cases
it might be useful to repeat an alarm as long until an acknowledgement is received.
OFF ON
PROG
* . 9 . 7 . 1 . 3 5 3 # . # . * .
Value
# .
OFF ON
PROG
Value Comment
0
EasyAlarm®
calls the alarm numbers within the calling number sequence just once
1..9
EasyAlarm
®
starts calling the calling numbers within the calling number sequence until the alarm is
confirmed by DTMF 0 or until the programmed value is reached! (factory setting =2)
9.3 Entry/Exit delay
The appropriated register 4 8 can be read-out or modified as follows:
OFF ON
PROG
* . 9 . 7 . 1 . 3 4 8 # . # . * .
Value
# .
OFF ON
PROG
Value Comment
0..255 Time in seconds (factory setting=20)
9.4 Mains power loss timeout
The appropriated register 6 3 can be read-out or modified as follows:
OFF ON
PROG
* . 9 . 7 . 1 . 3 6 3 # . # . * .
Value
# .
OFF ON
PROG
Value Comment
1..255 Period for mains power loss, before a alarm is activated : in 10 minute steps ! (deviation:-10/+0min)
(factory setting=2, i.e.. alarm is triggered if the mains voltage precipitates during 10..20min).
9.5 Signalling
9.5.1 Signalling through alarm unit
It is possible to signal the inactive waiting period with one beep every two seconds. Proceed as follows:
OFF ON
PROG
* . 9 . 7 . 1 . 3 0 5 # . # . * .
Value
# .
OFF ON
PROG
Signalling.. Value
Mains loss at power-on Selected mode after power-on Exit Beep every 2 sec. Entry : 2 Beep
0

  
1

  
2
   
3
   
4
   
Value
Value
Value
Value
Prog. 2