Leitch Neo AS-3901-B, Installation And Operation Manual

Page: 43 / 67

28 AS-3901-B and -C Installation and Operation Manual
Chapter 3: Operation
Enabling or Disabling an Alarm Parameter
To enable or disable an alarm parameter, follow these steps:
1. Select
Alarms , then select Config , and then press Enter .
2. Select one of the alarm parameters, and then press Enter .
3. Press Enabled or Disabled .
4. Press Enter to activate the selection.
Restoring Default Settings
To restore the alarms to their default settings, follow these steps:
1. Select
Alarms , select Config , and then press Enter .
2. Scroll down the list of alarms, and then select Reset.
3. Press Enter to activate the selection.
The following table lists the default alarms for the AS-3901-B and -C
modules. You can enable or disable these settings, but you cannot
change the level of the alarm.
.
State Recovery Parameter Availability
The parameter settings for this module are automatically saved onto the
3901RES-E resource module installed in your NEO frame every five
minutes. If a module should fail and be replaced with a cold spare, the
state parameters can be automatically recovered. For more information
on this feature, see the
NEO FR-3901, FR-3903, and FR-3923
Mounting Frames Installation and Operation Manual (Edition E and
above).
Table 3-3. AS-3901-B and C Default Alarms
Card-Edge
Alarm
Name of Alarm
Alarm
Level
Meaning (When Lit)
DARSLock DARS Lock Minor Loss of DARS lock