Leitch Neo AS-3901-B, Installation And Operation Manual

Page: 39 / 67

24 AS-3901-B and -C Installation and Operation Manual
Chapter 3: Operation
Operator and All List Parameters
This complete list of parameter settings is arranged so that the settings
most likely requiring changes are placed at the top of the list. Items on
the bottom of the list are the least likely to require changing. Parameters
with the designation [RO] are “read-only.” An asterisk (*) indicates the
default user range or value.
The All List is a long flat list of all the available parameters, arranged
from the most-used to least-used. It is intended for a “Supervisor”
security designation. The Operator List is a condensed version of the
All List, and is intended for an “Operator” security designation. The
following table shows all available parameters. Parameters accessed
only from within the All List are shaded in gray.
See
“Navigating the Operator and All Lists” on page 23 for instructions
on navigating this list using card-edge controls.
Note
You can reset the default values
for all of the parameters
automatically via the
FctryRcl
parameter, found in this table.
Table 3-2. Operator and All List Parameters
Card-Edge ID
Parameter
Name
Function User Range
AES_Prsnt
[RO]
AES1 to AES2 In
present Detects the presence of signal at inputs 1 to
inputs 2
• ==
• 1=
• =2
• 12
AES1Format to
AES2Format AES1 In to AES2
In data format Selects the input format for data inputs 1 to
input 2
• PCM*
• Non-PCM
Delay_1A,
Delay_1B,
Delay_2A,
Delay_2B Delay: AES1a to
Delay: AES2b Adjusts the delay for AES1a channel to
AES2b channel 0* to 1320.00 msec
Gain_1A,
Gain_1B,
Gain_2A,
Gain_2B Gain: AES1a to
Gain: AES2b Adjusts the gain for AES1a channel through
to AES2b channel -18.0 to +18.0 dB
(0 dB*)
DitherMode Output Dither
Mode Selects the Dithering Mode for all outputs
• None*
• On