Leitch DMX-3901-A, Installation And Operation Manual, Page: 42 / 64

DMX-3901-A Installation and Operation Manual 27
Chapter 3: Operation
Enabling or Disabling an Alarm Parameter
To enable or disable an alarm parameter, follow these steps:
1. Select
Alarms , then select Config , and then press Enter .
2. Select one of the alarm parameters, and then press Enter .
3. Press Enabled or Disabled .
4. Press Enter to activate the selection.
Restoring Default Settings
To restore the alarms to their default settings, follow these steps:
1. Select
Alarms , select Config , and then press Enter .
2. Scroll down the list of alarms, and then select Reset.
3. Press Enter to activate the selection.
The following table lists the default alarms for the DMX-3901-A
module. You can enable or disable these settings, but you cannot change
the level of the alarm.
Table 3-3. DMX-3901-A Default Alarms
Card-Edge
Alarm ID
Name of Alarm
Alarm
Level
Meaning
SdiPrsnt [RO] SDI Input Video
Present
Major Loss of SDI input
de-embedding
Grp1_Err [RO] Group 1 Error Status Major Group 1 de-embedding
error
Grp2_Err [RO] Group 2 Error Status Major Group 2 de-embedding
error
Grp3_Err [RO] Group 3 Error Status Major Group 3 de-embedding
error
Grp4_Err [RO] Group 4 Error Status Major Group 4 de-embedding
error