52
Heating and drive
button flash simultaneously, an error
is present (see Section Error message [17]).
The LED on the
Drive On/Off (30)
button displays the condition of the drive.
LED status
Drive On/Off (30)
Condition
LED off
Drive is switched off
LED continuously green
Drive is switched on
drive
15.7 Status LED display
LED status
Heating On/Off (31)
Condition
LED off
Heating is switched off.
LED flashes green
Heating is switched on. Temperature is outside the tolerance.
LED continuously green
Heating is switched on. Temperature is inside the tolerance.
The LED on the
Heating On/Off (31)
button displays the condition of the heating.
Heating
15.6 Display symbols for the air volume (Display 37)
15.5 Display symbols for the welding temperature (Display 36)
•
Welding temperature too high, cool-down process.
Down arrow
shows that the desired
lower temperature
has not yet been reached.
The flashing value designates the currently achieved actual value (470); the value below
(450) shows the setpoint of the individual setting.
•
Welding temperature too low, the heating process
up arrow
indicates that the desired
higher temperature
has not yet been reached. The
flashing number designates the currently achieved actual value (430); the value below
(450) shows the setpoint of the individual setting.
Actual and setpoint value of the air volume
Actual and setpoint value of the welding speed
The arrow in the display for the welding speed indicates the drive direction.
15.4 Display symbols for the welding speed (Display 35)
Summary of Contents for UNIROOF 300
