Leica M500 N, Service Manual

Page: 59 / 92

Service manual Leica M525 Replacing modules
Doc Code 10 665 751 5-5 04/2004 - EBTH Update 07/2007
5.1.5 Removing the multifocal motor
1. Remove counter weight and lower cover as described in
paragraph 5.1.2.
2. Pull out motor connector P5 [Fig.11-1] from motor controller
board through the notch in the illuminator (lower part).
3. Loose two screws [Fig.11-2] of motor-holding clip.
4. Take out the motor sideways from motor-holding clip.
5.1.6 Removing the switchboard
1. Remove counter weight and lower cover as described in
paragraph 5.1.2.
2. Pull out the switchboard plug P6 (Fig 11-3) from motor controller
board through the notch in the illuminator (lower part).
3. Remove two screws [Fig.12-1] of the switchboard and remove
switchboard in direction of the motor.
5.1.7 Removing the multifocal objective (10 712 073) from the
illumination device (10 712 092)
1. Remove counter weight and lower cover as described in
paragraph 5.1.2.
2. Pull off connectors from motor controller board as describes in
paragraph 5.1.1.
3. Separate zoom (upper part) and illuminator (lower part) from
one another as described in paragraph 5.1.1.
4. Loose the two screws (Fig 13-1) of the motor holding clip.
5. Take out the motor sideways from motor holding clip until no
more affect the gear rim from multifocal.
Fig 11
1
2
M3x5
DIN912
3
Fig 12
1
M2.5x5
DIN 7985
Fig 13
M3x5
DIN912
1