Leica GR10, Operational Manual

Page: 155 / 317

Printed Documentation
of the interval.
•
During a wake-up session all data streams and logging sessions that had been
configured and activated before the start of the wake-up session will automatically
resume streaming and logging. Additional data streams and logging sessions can be
configured during the intervals.
•
The receiver starts booting 2 minutes before the configured time to ensure that the
software is fully started by the configured start time.
•
The receiver powers down 1-30 seconds after the configured time. Logging files may
not be finalised before the receiver is powered down. These files will be finalized when
the receiver boots the next time.
•
After the last interval of a wake-up session has ended, the receiver is powered down
and stays off. Remote access is not possible after the power down.
Setting Descriptions
The table below describes the fields in the Wake-up sessions page.
Settings Description
Icon Wake-up session is active and running.
Wake-up session is inactive or the last wake-up
session has ended.
Wake-up session is active but is currently not running.
Name
The configured name of the wake-up session.
If a wake-up session was configured when creating a logging
session, the name shown will be the logging session name.
Next start time
The time the receiver is configured to wake up next.
Next end time
The time the receiver is configured to power down next.
Remaining interv.
Number of remaining repetitions of the wake-up session.
Delete
Press delete to permanently delete the corresponding wake-up
session.
Edit wake-up session
Press to edit the wake-up session.
Create new wake-up session
(copy)
Press to create a new wake-up session based on the existing
wake-up session.
Activate The wake-up session is deactivated. Press to activate.
The wake-up session is activated. Press to deactivate.
Create new wake-up session
Press to create a new wake-up session.
154