Leica GPS1200+, Technical Reference Manual

Page: 1072 / 1442

Reference Line 1072
)
The Map page provides an interactive display of the defined refer-
ence line.
33
11. CONT (F1)
12. Walk to the first point to be measured.
13. REFLINE Measure Points 42.5
<Point ID: S1>
14. OCUPY (F1) starts collecting data.
15. If required, check information, for example on the satellites, the
memory or the battery.
16. When <Auto STOP: No> in CONFIGURE Point Occupation
Settings , STOP (F1) when enough data is collected. At least one
epoch of data must be recorded.
19.6.1
17. When <Auto STORE: No> in CONFIGURE Point Occupation
Settings , STORE (F1) to store the point information.
19.6.1
)
The results are displayed on the screen. The values in the fields indi-
cate the position of the point being occupied relative to the reference
line.
)
It may happen that a point with the same point ID exists in the job. If
the codes and/or attribute values of the new and the existing point do
not match, a screen opens where they can be corrected.
)
Do not turn off the receiver.
Step Description Refer to
chapter