Leica Geosystems GS14, User Manual, Page: 32 / 54

1. Attach the GHT62 for CS15 or the GHT66 for CS20 holder to the
pole.
2. Insert the data storage device and the battery into the field control-
ler.
3. Clip the field controller into the holder and lock it by pushing the
locking pin into the locked position.
4. Press ON/OFF button on the field controller to switch on.
5. Insert the data storage device and the batteries into the GS14/GS16.
6. Press ON/OFF button on the GS14/GS16 to switch on.
7. Screw the GS14/GS16 to the top of the pole.
8. The field controller and GS14/GS16 are connected via Bluetooth.
4.1.4 Fixing the Field Controller to a Holder and Pole
This chapter is valid for all holders.
The GHT66 holder consists of the following components:
008545_001
a
b
c
f
d
e
g
h
i
GHT63 clamp
a Plastic sleeve
b Pole clamp
c Clamp bolt
GHT66 holder
d Locking pin
e Top clip
f Mounting plate
g Bottom clip
h Tightening screw
i Mounting arm
☞
For an aluminium pole, fit the plastic sleeve to the pole clamp.
1. Insert the pole into the clamp hole.
2. Attach the holder to the clamp using the clamp bolt.
3. Adjust the angle and the height of the holder on the pole to a com-
fortable position.
4. Tighten the clamp with the clamp bolt.
5. Before placing the CS field controller onto the mounting plate, ensure
that the locking pin is put into the unlocked position. To unlock the
locking pin, push the locking pin to the left.
008546_001
6. Hold the CS field controller above the holder and lower the end of
the CS field controller into the mounting plate.
Equipment setup
step-by-step
☞
Components of the
GHT66 holder
Fixing the field
controller and GHT66
to a pole step-by-
step
32 Operation