Leibinger JET3 up, Operating Manual, Page: 270 / 412

Page 268 Job Editor Group 8
Release R1.06 JET3up
8.5.2.4 PrintGo – Hold off distance
The setting provides a filtering of unrequested PrintGo-signals (e.g. PrintGo with
bounces or double releasing). The value defines a length „x“ after the PrintGo-
signal in which every further signal will be ignored.
The delay is specified in the dimension set in the
<Basic settings> e.g. in mm.
The set value is shown on the accordant display field.
Figure 144 PrintGo-holdoff distance
Double releasing:
PG Signal(s)
PrintGo with „chatters“:
PG Signal(s)
Filtering active
T
ext
T
ext
T
ext
T
ext
T
ext
T
ext
Filtering active
Printed
trigger
marks
Printed
trigger
marks
Object which
should be printed