INSTRUCTION MANUAL
AAL Profiline Mobil emergency call receiver
HC-502-BA V1.07 Mobil emergency call receiver Page 1 of 4
AAL
Homecare
Fon +49 2208 9339170 Fax +49 2208 9339063 www.aal-homecare.com
Warning
The use of a call device does not release supervisors from the obligation to supervise the persons supported by such
a device. This system is radio-based and must therefore not be used for monitoring purposes if life-threatening
conditions are foreseeable.
Package contents
Product
Order number
1
Frequency
1
AAL
Profiline
Mobil emergency call receiver
USB power supply unit
and 1 m USB extension cable included
HC-502
869.23 MHz
Instruction manual
HC-502-BA
1
Order number and frequency can be found on the identification decal.
Note: While unpacking, each shipment should be inspected for completeness and damage.
Note: In this manual, the
AAL Profiline Mobil emergency call receiver
is referred to as „
emergency call receiver
“.
Fig. 1: emergency call receiver
Putting into Operation:
Programming / Deleting Transmitters to / from the Emergency Call Receiver
The “programming” to the radio receiver required for initial putting into operation is described in Fig. 3, and the optional “deletion“
from the radio receiver is described in Fig. 6.
Checking the Safe Range of the Radio Link
The range of the matching AAL
Profiline
transmitters meets the requirements of the technical inspection body of the German health
insurance companies. Within buildings, a range of approx. 30 m can be expected. The range depends to a large extent on the local
conditions.
Before using the transmitter for the first time, an interference-free operation of the radio link should be ensured. Proceed as follows:
1. Switch
on
all electronic entertainment and communication devices (e.g., television sets, game consoles, and computers) in the
immediate vicinity.
2. Check if the radio message is received by the emergency call receiver at a distance exceeding the intended usage distance by
approx. 5 to 10 m. Make sure that the message is trigged by a single radio signal.
“Battery Low” Message
Each time a call is issued, the transmitter battery status is also transmitted. If a “battery low” message is received, the battery of the
transmitter should be replaced within the following weeks. This message is indicated by a yellow flashing LED. The message can
be reset by pressing any button.
Flash
LED
Right-hand
button:
Alarm type
selection
Transmitter
programming
Left-hand
button:
Shut-down
transmitter
programming
MediPad
Contact sensor mat
Emergency call transmitter
Middle button:
Resetting
VarioPull
Wireless
momentary pull
switch
Emergency
call pad
Operating
indicator
Fig. 2 (example): selection of compatible transmitters