Lehigh DTM-MA, Manual

Page: 21 / 46

2.6.2 Timeclock events
In a timeclock event you specify what will happen when. Up to 25 events may be defined. Each event
may occur once per day.
Event actions:

none: no action, use this for an empty event.

Preset: activates a preset. Select the preset name.

Close Wall: Select the area to be un-joined.

Open Wall: Select the areas to be joined.

Output: Controls an output. Select the output port and setting.

Lock remotes: locks remote stations that can be locked.

Unlock rmts: unlocks remote stations.

Start LtsOut: starts LightsOut.

Stop LtsOut: stops LightsOut.

Occ Sns On: enables all occupancy sensors for this station, if any.

Occ Sns Off: disables all occupancy sensors for this station, if any.

DayLt Sns On: enables all daylight sensors for this station, if any.

DayLt Sns Off: disables all daylight sensors for this station, if any.

Start Autoseq: starts auto-sequencing.

Stop Autoseq: stops auto-sequencing.
Event times:

Select the hours and minutes of the event time. These apply to the Time specifier – exact or
relative to sunset or sunrise.

Set the Time specifier to determines how the hours and minutes setting is used. The choices
are:
o
Never: the event will never occur.
o
AM: hours and minutes are exact.
o
PM: hours and minutes are exact.
o
Before sunrise: hours and minutes are the time before sunrise.
o
After sunrise: hours and minutes are the time after sunrise.
o
Before sunset: hours and minutes are the time before sunset.
o
After sunset: hours and minutes are the time after sunset.

Set the days of the week that the event will occur on. The holiday setting applies to all the
Timeclock Holidays (section 2.1.3.3) and will override the day of the week.
17