LEGRAND Raritan SRC-0100, User Manual

Page: 418 / 698

Chapter 8: Using the Command Line Interface
406
Setting Data Logging Measurements Per Entry
This command defines the number of measurements accumulated per
log entry.
config:# src measurementsPerLogEntry <number>
Variables:

<number> is an integer between 1 and 600. The default is 60
samples per log entry.
For more information, see
Setting Data Logging
(on page 294).
Specifying the Device Altitude
This command specifies the altitude of your SRC above sea level (in
meters). You must specify the altitude of SRC above sea level if a
Raritan's differential air pressure sensor is attached. This is because the
device's altitude is associated with the altitude correction factor. See
Altitude Correction Factors
(on page 650).
config:# src deviceAltitude <altitude>
Variables:

<altitude> is an integer between -425 and 3000 meters.

Note that the lower limit "-425" is a negative value because some
locations are below the seal level.