LEGRAND Raritan SRC-0100, User Manual

Page: 415 / 698

Chapter 8: Using the Command Line Interface
403
Clearing Event Log
This command removes all data from the event log.
# clear eventlog
-- OR --
#
clear eventlog
/y
If you entered the command without "
/y
," a message appears,
prompting you to confirm the operation. Type
y
to clear the event log or
n
to abort the operation.
If you type y, a message "Event log was cleared successfully" is
displayed after all data in the event log is deleted.
Clearing Diagnostic Log for Network Connections
This command removes all data from the diagnostic log for both the EAP
authentication and WLAN connection.
# clear networkDiagLog
-- OR --
# clear networkDiagLog /y
If you entered the command without "
/y
," a message appears,
prompting you to confirm the operation. Type
y
to clear the log or
n
to
abort the operation.
Configuring the SRC Device and Network
To configure the SRC device or network settings through the CLI, it is
highly recommended to log in as the administrator so that you have full
permissions.
To configure any settings, enter the configuration mode. Configuration
commands are case sensitive so ensure you capitalize them correctly.