LEGRAND Raritan SRC-0100, User Manual

Page: 392 / 698

Chapter 8: Using the Command Line Interface
380
config:#
?
In the diagnostic mode:
diag:#
?
Press Enter after pressing the ? command, and a list of main commands
for the current mode is displayed.
Tip: To automatically complete a command after typing part of the full
command, see
Automatically Completing a Command
(on page 524).
To re-execute one of the previous commands, see
Retrieving Previous
Commands (on page 524).
Querying Available Parameters for a Command
If you are not sure what commands or parameters are available for a
particular type of CLI command or its syntax, you can have the CLI show
them by adding a space and the help command (?) or list command (ls) to
the end of that command. A list of available parameters and their
descriptions will be displayed.
The following shows a few query examples.
To query available parameters for the "show" command:
# show ?
To query available parameters for the "show user" command:
# show user ?
To query available role configuration parameters:
config:# role ?
To query available parameters for the "role create" command: