LEGRAND Raritan SRC-0100, User Manual

Page: 388 / 698

Chapter 8: Using the Command Line Interface
376
Logging in to CLI
Logging in via HyperTerminal over a local connection is a little different
than logging in using SSH or Telnet.
If a security login agreement has been enabled, you must accept the
agreement in order to complete the login. Users are authenticated first
and the security banner is checked afterwards.
With HyperTerminal
You can use any terminal emulation programs for local access to the
command line interface.
This section illustrates HyperTerminal, which is part of Windows
operating systems prior to Windows Vista.
To log in using HyperTerminal:
1. Connect your computer to the product via a local (USB or RS-232)
connection.
2. Launch HyperTerminal on your computer and open a console
window. When the window first opens, it is blank.
Make sure the COM port settings use this configuration:

Bits per second = 115200 (115.2Kbps)

Data bits = 8

Stop bits = 1

Parity = None

Flow control = None
Tip: For a USB connection, you can determine the COM port by
choosing Control Panel > System > Hardware > Device Manager, and
locating the "Dominion PX2Serial Console" under the Ports group.
3. In the communications program, press Enter to send a carriage
return to the SRC. The Username prompt appears.
4. Type a name and press Enter. The name is case sensitive. Then you
are prompted to enter a password.
5. Type a password and press Enter. The password is case sensitive.