Chapter 6: Using the Web Interface
258
Warning: If you create an event rule for the external beeper but
disconnect it when an event causes it to beep, the beeper no longer
beeps after it is re-connected even though the event triggering the
beeping action remains asserted.
Internal Beeper
You can have the built-in beeper of the SRC turned on or off when a
certain event occurs.
Operation:
1.
Choose Device Settings > Event Rules >
.
2.
Select 'Internal beeper' from the Action list.
3.
Select an option from the Operation field.
Turn beeper on: Turns on the internal beeper to make it buzz.
Turn beeper off: Turns off the internal beeper to make it stop
buzzing.
Log an Event Message
The option 'Log event message' records the selected events in the
internal log.
The default log message generated for each type of event is available in
the section titled
Default Log Messages
(on page 244).
Summary of Contents for Raritan SRC-0100
