LEGRAND Raritan SRC-0100, User Manual

Page: 161 / 698

Chapter 6: Using the Web Interface
149
Schroff LHX/SHX
You must enable the LHX/SHX support for the SRC to detect the
presence of a supported Schroff
®
LHX/SHX heat exchanger. See
Miscellaneous
(on page 314).
After enabling the LHX/SHX support and connecting a supported Schroff
®
LHX/SHX heat exchanger to the SRC, the SRC shows the connected
device type in place of 'Feature Port' in the menu -- LHX 20, LHX 40 or
SHX 30.
Note: For connection instructions, see
Connecting a Schroff LHX/SHX
Heat Exchanger
(on page 69).
To open the LHX/SHX page, click 'LHX 20', 'LHX 40' or 'SHX 30' in the
Menu
(on page 104). Then you can monitor and administer the connected
LHX/SHX device with the following.

Name the heat exchanger

Monitor LHX/SHX built-in sensors and device states

Configure the air outlet temperature setpoint

Configure the default fan speed

Configure the air temperature/fan speed thresholds (for alert
generation)

Request maximum cooling using the fan speed and opening the cold
water valve

Acknowledge alerts or errors remotely, such as failed LHX/SHX
sensors or emergency cooling activation

Accumulative operating hours

Indicate the number of power supplies present and whether a
condenser pump is present
Available information/operation is model dependent. For example, only
LHX devices can show sensor alerts. See your LHX/SHX user
documentation for details.
Important: The LHX/SHX settings are stored on the port where the
LHX/SHX device is connected, and are lost if that device is
re-connected to a different SRC port.