LEGRAND Raritan PX3TS, User Manual

Page: 595 / 911

Chapter 9: Using the Command Line Interface
575
Specifying the Device Altitude
This command specifies the altitude of your PX3TS above sea level (in meters).
You must specify the altitude of PX3TS above sea level if a Raritan's differential
air pressure sensor is attached. This is because the device's altitude is
associated with the altitude correction factor. See
Altitude Correction Factors
(on page 844).
config:# pdu deviceAltitude <altitude>
Variables:
•
<altitude> is an integer between -425 and 3000 meters.
•
Note that the lower limit "-425" is a negative value because some locations
are below the seal level.
Setting the Z Coordinate Format for Environmental Sensors
This command enables or disables the use of rack units for specifying the
height (Z coordinate) of environmental sensors.
config:# pdu externalSensorsZCoordinateFormat <option>
Variables:
•
<option> is one of the options: rackUnits or freeForm .
Option Description
rackUnits The height of the Z coordinate is measured in
standard rack units.
When this is selected, you can type a numeric value in
the rack unit to describe the Z coordinate of any
environmental sensors or actuators.
freeForm Any alphanumeric string can be used for specifying
the Z coordinate.
Note: After determining the format for the Z coordinate, you can set a value for
it. See
Setting the Z Coordinate (on page 665).