LEGRAND Raritan PX3-3000 Series, User Manual

Page: 266 / 977

Chapter 6: Using the Web Interface
245
How the Automatic Management Function Works
This setting is configured on
Peripherals
(on page 231).
After enabling the automatic management function:
When the total number of managed sensors and actuators has not
reached the upper limit yet, PX3 automatically brings newly-connected
environmental sensors and actuators under management after detecting
them.
PX3 can manage up to 32 sensors/actuators.
After disabling the automatic management function:
PX3 no longer automatically manages any newly-added environmental
sensors and actuators, and therefore neither ID numbers are assigned
nor sensor readings or states are available for newly-added ones.
You must manually manage new sensors/actuators. See
Peripherals
(on
page 231).
Managing One Sensor or Actuator
If you are managing only one sensor or actuator, you can assign the
desired ID number to it. Note that you cannot assign ID numbers when
managing multiple sensors/actuators at a time.
Tip: When the total of managed sensors/actuators reaches the maximum
value, you cannot manage additional ones. The only way to manage any
sensor/actuator is to release or replace the managed ones. To replace a
managed one, assign an ID number to it by following the procedure
below. To release any one, see
Peripherals (on page 231).
To manage only one sensor/actuator:
1. From the list of "unmanaged" sensors/actuators, click the one you
want to manage.