LEGRAND Raritan PX3-3000 Series, User Manual

Page: 141 / 977

Chapter 5: Introduction to PDU Components
120

Cycle: Power cycle the outlet group.
5. A confirmation message appears. Press or to select Yes
or No, and then press .

Yes: Confirm the operation.

No: Abort the operation.
6. Verify that the selected outlet group is switched on or off, depending
on the option you selected in the above step.

Check the outlet group state shown on the LCD display -- red or
green circles.

Check each member outlet's LED of the group. A green LED
indicates that the outlet is turned off, and a red LED indicates
that the outlet is turned on.
7. To return to the Main Menu, press several times until the Main
Menu is shown.
Peripherals
If there are no Raritan environmental sensor packages connected to your
PX3, the LCD display shows the message "
No managed devices" for the
"Peripherals" menu command.
If you have enabled the front panel actuator control function, you can
switch on or off a connected actuator using the LCD display. See
Miscellaneous (on page 447).
To show environmental sensor or actuator information:
1. Press or to select "Peripherals" in the Main Menu, and
press .
2. The display shows a list of environmental sensors/actuators.

If the desired sensor or actuator is not visible, press or
to scroll up or down.

When the list exceeds one page, the currently-selected
sensor/actuator's ID number and total of managed
sensors/actuators are indicated in the top-right corner of the
display.

If any sensor enters the warning, critical, or alarmed state, like
'Tamper Detector 1' shown below, it is highlighted in yellow or
red. For color definitions, see
Yellow- or Red-Highlighted
Sensors
(on page 238).