INSTRUCTION / INSTALLATION SHEET
ev
ō
Q™ 5000 Home Theater 10” 150W
Sub-Woofer
IS-0260 Rev. E
301Fulling Mill Road, Suite G
Middletown, PA 17057
Phone (800) 321-2343 / Fax (717) 702-2546
www.onqlegrand.com
©Copyright 2010 by Legrand All Rights Reserved.
Page 1 of 2
1. Introduction
Legrand offers the ev
ō
Q™ 5000 Home Theater 10” 150W Sub-
Woofer for those instances where extended base response is
required. This speaker, part number HT5104, (see
Figure 1
), is
optimized for the home theater environment. It features a 10”
poly cone woofer, a ported cabinet and is typically placed on
the floor (see
Figure 4).
Note: This Legrand ev
ō
Q™ 5000
Home Theater 10” 150W
Sub-Woofer is not a moisture resistant speaker.
2. Description
The Legrand ev
ō
Q™ 5000 Home Theater 10” 150W Sub-Woofer is a cube approximately 15.5” tall x 12.25”
wide x 14.3” deep. It is made of black vinyl covered MDF, and is a ported unit designed to be placed where
base response is best, supporting the non-directional nature of its base frequency output. It features RCA
connections for line level input, a volume control, a crossover bypass switch and adjustment (50-200Hz) and a
phase reversal switch. It also features a removable fabric grill cloth to enhance the sub-woofer’s appearance
when installed. This is a powered sub-woofer, and as such needs to be placed within 6 feet of a 120VAC 60Hz
electrical outlet.
3. Installation
Installation of the ev
ō
Q™ 5000 Home Theater Sub-Woofer, is best accomplished at multiple times during new
construction, at “Rough-in” before the drywall is installed, and at “Trim-out” after the drywall is installed and
painted
.
A. “Rough-in”
steps:
1. The
ev
ō
Q™ 5000 10” 150W
Sub-Woofer may be installed in
a variety of ways with respect to
the rest of the home theater
equipment and structured wiring
system. It contains line level
inputs (RCA connectors)
(
see
Figure 2)
2.
Separate source outputs from a home theater receiver may be run to the sub-
woofer and associated speakers independently. The Legrand HECC for instance
has separate outputs for a sub-woofer, from the rest of the speakers.
3.
Pre-wire cabling from the source location to the intended sub-woofer location can be RG6QS coaxial
cable or RCA jumper cables depending on the intended location of the sub-woofer.
4.
To cable from the source using coax cable in the wall, pre-wire two RG6QS cables from the source
location to the intended sub-woofer location.
5.
To cable from the source at line level utilizing RCA jumper cables, simply connect the jumper cable
from the source to the sub-woofer.
Figure 2
Figure 1
