HOMETOUCH
User manual
122
Burglar alarm
In this section you can display the Burglar Alarm system status, the current faults, display the
status, activate the partitions and switch the Burglar Alarm system on by means of the insertion
scenarios.
Note
: this function is only present if you have a BTicino Burglar Alarm system (alarm control units 4200,
4201, 4203) and have made the connection with the control unit following the procedure.
Caution
: not all the functions shown in this manual are available for all countries.
Check with your retailer which functions are available for your market
A Colour indication of the status of the system:
No colour
= burglar alarm system not inserted
Green
= burglar alarm system inserted (at least one scenario or partition inserted)
Red steady
= an alarm has triggered and has been acknowledged (seen but not resolved by
deactivating the system and removing the cause of the alarm)
Flashing red
= alarm in progress
B Icon indication of the status of the system:
Burglar-alarm system connected
Burglar-alarm system disconnected
Alarm on the burglar-alarm system (an alarm on at least one partition)
C Insertion scenario active
D No. of inserted partitions
1. Returns to the Home Page
“Scenario name” (e.g. Night)
Partitions inserted according to
the control unit preset scenario
“Partially inserted”
Partitions manually added the
page
16:01
Wednesday, 6 December
Total insertion
2 partitions
Everything is turned
off and shutters
are closed
Open Door
Look outside
Generic
Public
External
intercom rin...
B
C
D
A
NO
ACTIVE ZONE
Kitchen Thermost...
23.4 °C
1
