RS-232 Connector Pin-Out
The OneLINK device passes signals from a third-party device to the connected camera.
OneLINK Receiver - RS-232 Control Port
Pin
Signal
1
(not used)
2
(not used)
3
(not used)
4
(not used)
5
(not used)
6
GND
7
RX (from TX of controller)
8
TX (to RX of controller)
Mounting the OneLINK Device
Rack and under-table mounting kits are available for the receiver. Follow the mounting instructions
supplied with the kit.
About Installations Using Half-Recessed Ceiling Mounts
If the connected camera is mounted in an In-CEILING Half-Recessed Ceiling Mount for RoboSHOT
®
series cameras, and the mount’s IR receiver will be used to forward commands to the camera, this must
be powered separately using Power Extension Module 998-2225-051. Cameras powered by OneLINK
devices cannot supply power to the mount's IR receiver.
Complete Manual for the OneLINK Bridge Express AV Interface
4