6/8
CoNTeNTs
Technical data sheet: S000077897EN-1
Updated:
Created: 10/03/2014
Cat. No(s): 0 489 14
Lighting management sensor - PIR
8. seTTINgs
8.1 Detection parameters
Time delay:
Length of time the load is on after detection occurs.
sensitivity:
Detection range setting.
modes:
auto on/auto off mode:
Comes on automatically:
- At the detection of a presence if there is an insufficient natural level of
light.
Turns off automatically:
- If no presence is detected and at the end of the time delay set.
- Or if the natural light level is sufficient (regulation activated).
Any new detection triggers an automatic switch-on if there is
insufficient light.
Walk-through mode:
- If no presence is detected in the 20 seconds following an initial
detection, the product will cut off the load after 3 minutes.
- If another presence is detected in the 3 minutes following initial
detection, the device will cut off the load at the end of the set time
delay.
manual on/auto off mode:
Manual switch-on, automatic switch-off:
- When no presence is detected and at the end of the set time delay.
After switch-off, any new detection within a 30-second period triggers
an automatic switch-on. The Restart function must be activated.
After 30 seconds the device is switched on via a manual control.
Detection system:
Initial detection:
The load is switched on as soon as the first detection
occurs if the natural light level is below the light level threshold.
maintain:
The load remains active if another presence is detected.
Restart:
In manual mode. After switch-off, any new detection within a
30-second period triggers an automatic switch-on.
After 30 seconds the device must be switched on manually.
Possible in Manual on/Auto off mode only.
alarm:
an audible signal is emitted before switch-off (1 minute before,
then 30 seconds, then 10 seconds).
sensor parameter
Default
value
modifiable
parameters
Configuration
tools
0 882 30 0 882 35
Time delay
15 min
3, 5, 10, 15, 20 min
−
0 - 59 min 59 s
−
sensitivity
PIR (very
high)
Low, medium,
high, very high
m
odes
auto on/auto off
Inactive
Activate/
Deactivate
Walk-through
mode
Active
Activate/
Deactivate
manual on/auto
off
Inactive
Activate/
Deactivate
Detection system
Initial
PIR
Not modifiable
−
maintain
PIR
Not modifiable
−
Restart
PIR
PIR and/or US, PIR,
US, Deactivate
−
alarm
Inactive
Activate/
Deactivate
−
8. seTTINgs (continued)
8.2 Light parameters
Light level threshold:
Value at which the load comes on if the
natural light level is less than the setting.
eye function:
Value 0 (eye on configuration tool 0 882 30) is
used to save the ambient light level in the room as a light level
threshold.
advanced mode:
Calibration:
The ambient light level measured with a luxmeter
must then be transmitted to the sensor.
Regulation:
Automatic switch-off of the load 10 minutes after the
light level threshold is exceeded with an additional safety threshold
(to avoid lights switching off at the wrong moment).
Light contribution:
Quantity of additional lux brought in by the load
being switched on.
When the light contribution parameter is set to "Auto" (value 0) on the
configuration tool Cat. No. 0 882 30, the sensor automatically calculates
the light contribution.
8.3 modifying the parameters using the configuration tools
attention:
Do not put on the blanking plate when
modifying parameters via a configuration tool.
• 0 882 35: Simplified configuration tool
• 0 882 30: Advanced configuration tool
When the sensor receives an IR command via a configuration tool,
it emits a beep acknowledging the modification.
For more information about setting parameters, refer to the data sheet
for the configuration tool Cat. No. 0 882 30.
- Restore to factory settings:
1
st
press: Short press on LEARN, the LED flashes slowly.
2
nd
press: Hold down LEARN for 10 seconds until the LED flashes
quickly.
sensor parameter
Default
value
modifiable
parameters
Configuration
tools
0 882 30 0 882 35
Light level threshold
300 lux
20, 100, 300, 500,
1000 lux
−
5 - 1275 lux
−
a
dvanced
mode
Calibration
−
0 - 99,995 lux
−
Regulation
Active
Activate/
Deactivate
−
Light contribu-
tion
Auto
Auto - 1275 lux
−
