LEGRAND 0 026 93, Technical Data Manual

Page: 7 / 20

7/20
ContentS
Technical data sheet: S000092664EN-1 Updated: Created: 03/05/2016
Catalogue number(s): 0 026 93
KNX 4 channels binary input interface
6 . parameterS anD CommUniCation objeCtS (continued)
6 .2 .10 Communication object “multiple operation”
The communication object "Multiple Operation" will be shown in
Fig.6.10. If the input is operated several times within a defined period, a
defined object value can be modified by the number of operations.
Fig 6.10 Communication object “Multiple operation”
No. Function Object name
Data
type
Flags DPT
1~4
CH X
1-fold
(1~4)
Output
1-fold X(1~4)
1Bit C,T 1.001 DPT_Switch
The number of the communication object (maximum 4) is set
with the parameter “Max. number of operations(=Num. of objects)”.
If the input is operated several times within a defined period, the
objects will send the relevant telegram value on the bus, which the
telegram value is set with the parameter “value send (object “Tele.
Operation…-fold”)”. The objects will be described in the multiple
operation parameter chapter.
5
CH X
Long-
fold
Output
Long-fold, X
1Bit C,T 1.001 DPT_Switch
It is visible if parameter “Additional object for long operation”
selected “yes”. Once detected a long operation the object will send
telegram value on the bus, the telegram is set with the parameter
“value send (object “Tele. Long operation”)”.
Table 10 Communication object table “Multiple operation”
6 .2 .11 Communication object “Shutter control”
The communication object “Shutter Control” will be shown in Fig.6.11.
Fig.6.11 Communication object “Shutter Control”
6 . parameterS anD CommUniCation objeCtS (continued)
6 .2 .11 Communication object “Shutter control” (continued)
No. Function Object name
Data
type
Flags DPT
1
CH X
shutter UP/
DOWN
Output
shutter UP/
DOWN, X
1Bit C,T
1.008
DPT_UpDown
This communication object sends a shutter motion command (up
or down) to the bus.
Telegram value 0 move up
1 move down
2
CH X Stop/
lamella adj
Output Stop/
lamella adj, X
1Bit C,T
1.007
DPT_Step
This communication object sends a stop command or lamella
adjustment.
Telegram value 0 stop/adjust up
1 stop/adjust down
3
CH X
Upper
limit
position
Upper limit
position, X
1Bit C,W
1.002
DPT_Bool
The object is used to upper limit shutter moving.
Telegram value 0 no limit moving up
1 limit moving up
4
CH X
Lower
limit
position
Lower limit
position, X
1Bit C,W
1.002
DPT_Bool
The object is used to lower limit shutter moving.
Telegram value 0 no limit moving down
1 limit moving down
Table 11 Communication object table “Shutter Control”