1
Million Color LED Expandable Golf Cart Underbody Lighting Kit
This kit is recommended to be installed by a licensed professional. The improper installation of this kit will void all warranties.
The Control Box and Junction Box that are used to power the underbody tubes must be installed in a dry location! Having these
parts exposed to water or the elements will cause the kit’s controller to fail. Any water damage or corrosion to this part will VOID all
warranties.
PLEASE READ THE FOLLOWING INSTRUCTIONS THOROUGHLY BEFORE INSTALLING AND OPERATING THIS LED GOLF CART KIT.
4pc Golf Cart Kit Includes:
(2) 18” Flexible Tubes
(2) 28” Flexible Tubes
Control Box
Junction Box
Connection Cable
(2) Wireless Remotes
(8) Self Tapping Screws
(12) Zip-Ties
(8) Rubber Port Plugs
Golf Cart Kit Installation:
1.
Arrange the tubes out on the ground the way you plan on
installing them and test the kit to ensure proper
functionality before installing.
2.
Temporarily power the kit with any 12 volt source to ensure
it is functioning properly before you move forward with this
installation. Simply connect the red wire to the positive (+)
terminal and the black wire to any good bare ground metal
source or negative (-) terminal of a 12 volt battery. Power
the kit on to ensure full functionality. Once you have
determined the kit is functioning properly, remove the
power from your kit and begin the installation.
3.
Optional:
Raise and support the golf cart, if necessary.
4.
Clean the proposed mounting surfaces with an alcohol prep pad. The mounting surface should be between 45 and 85
degrees Fahrenheit to achieve the strongest bonding results from the double-sided adhesive tape. The surface area must
be free of all oils, moisture, dirt and wax in order for the supplied adhesive tape to bond and adhere to the installation
surface properly.
Optional:
To achieve the strongest bond between the lighting strips and the golf cart, you can use 3M™
Adhesion Promoter, which is sold separately from your kit.
5.
Start with the front 18” tube and mount it with wire facing the driver side with plenty of clearance from heat and moving
parts. The tubes are flexible and can be contoured if the undercarriage is not flat.
6.
Mount the side 28” tubes with the wires facing the front of the cart with plenty of clearance from heat and moving parts.
7.
Mount the rear 18” tube with the wire facing either side with plenty of clearance from heat and moving parts.
8.
Next, mount the junction box under the seat of the golf cart. The junction box must be mounted away from heat,
moisture, and the elements.
9.
Starting with the rear tube, run the wires to junction box. Make sure to
secure the wires tightly when going around any suspension parts and
exhaust by using the included zip-ties. Wires must be at least 10 inches from
the exhaust and away from any suspension parts. If a wire is pinched, the kit
may malfunction and could void the warranty. Run the wires along one side
of the golf cart and make sure to tightly secure it. Then, run the front tube
wires to the junction box. Ensure that all connections are secure.
10.
Run the connection cable to the junction box and ensure that the connector
is secure.
11.
Make sure the connection cable is mounted away from heat and moving
parts. Any excess wire will have to be bound and secured tightly with zip-
