2. Turn off the master power switch and unplug the machine.
3. Using a potholder or oven glove, lift the top heat shoe up and back and
then lower it onto the stop pins or the top of the pull roll cover (if the pins
have been removed).
4. Loosen the two bolts that hold up the bottom heat shoe and lower the
bottom shoe. This will expose both rollers so they can be cleaned much
more easily than if the heat shoes were in the way.
WARNING: Never clean the rollers while they are turning. While
turning, the rollers may catch your fingers and cause injury, or they
may catch your cleaning materials and damage the laminator. Unplug
the power cord while cleaning the rollers or performing other
maintenance on the machine. Turn the rollers by hand.
MISE EN GARGE: Ne jamais nettoyer les rouleaux pendant qu’ils
tournent afin d’éviter de se blesser et d’empecher que le produit de
nettoyage n’endommage l’intérieur de la machine. Débrancher le
cordon d’alimentation avant le nettoyage ou tout autre travail
d’entretien. Nettoyer d’abord la partie apparente des rouleaux, puis, a‘
l’aide de la commande de marche arriére, les faire tourner de facon à
pouvoir en nettoyer toute la surface.
AVERTENCIA: Nunca limpie los rodillos de goma mientras estén
girando. Al estar girando, los rodillos pueden atrapar sus dedos y
lastimarlos, o pueden atrapar sus artículos para limpieza y danar el
plastificador. Desenchufe el cordón eléctrico mientras está limpiando
los rodillos, o realizando otras tareas de mantenimiento en la máquina.
Gire los rodillos por mano.
Clean the rubber rollers with a mildly abrasive cleaning pad such as a white
Scotch Brite (Trademark of 3M) pad which may be purchased in the
household section of your grocery store (the green pads are too abrasive).
Use “COOL CLEAN” to clean the rollers (available through your local LEDCO
dealer). Rub firmly but do not scrub the rollers vigorously as this might mar
the surface. Do not use sharp metal objects or steel wool as these will also
mar the rollers.
The pull rollers should also be cleaned in the same manner. Turn off the
machine and turn the rollers by hand. Be sure to reposition and secure the
upper heat shoe before beginning to laminate.
6-5 LUBRICATION
50
