RMPM2T-1
TECHNICAL DATA
Rio Rancho, NM, USA
www.lectrosonics.com
Installing One M2T into a Single Rack
The M2T transmitter occupies a half rack space. This
kit provides the hardware needed to mount one M2T or
DSQD into a single rack space.
NOTE: Steps 1-6 will require original mounting
hardware that came with the units. Part numbers
are included in case individual items need to be
reordered.
1. Remove the Trim Cap (Part #P1330) from both
sides of the front panel of the M2T unit to be
rack mounted.
2. Remove the breakaway tabs on both sides of the
Chassis Cover Panel. This requires the use of a
flat-blade screwdriver inserted into the slots and
levering the tabs away on each side of the unit.
3. Insert the Flange Bracket (Part #27076) into the
open slot in the left-front side of the Chassis
Cover Panel.
4. Insert two (2) Cap Screws (Part #28885) through
the Rack Handle (Part #27082) holes and install
the Rack Handle onto the Flange Bracket through
the holes in the unit’s front panel. Firmly tighten
the Cap Screws using the long leg of the Hex
Wrench as shown.
5. Unless also installing a Front Mounted Antenna,
insert the Hole Plug (Part #35959) into the open
antenna hole in the Flange Bracket by aligning the
flat sides of the plug with those of the bracket hole
and pushing into place until flush.
6. Install the Front Tie Bracket (Part #25991) into
the open slot in the right side of the M2T Chassis
Cover Panel with the protruding nuts facing rear-
ward, affix with two (2) Cap Screws (Part #28885)
provided and firmly tighten with the Hex Wrench.
See next page.
NOTE: Steps 7-11 require parts from the
(RMPM2T-1) M2T Single Rack Mount Kit.
Single Rack Mount Kit for M2T and DSQD
