LeCroy USB Protocol Suite Advisor T3, User Manual

Page: 64 / 388

Chapter 2: General Description USB Protocol Suite User Manual
50
LeCroy Corporation
2.19 USB Mobile T2 and USB Mobile HS
USB Mobile T2 (and USB Mobile HS) components are:
• One LeCroy USB Mobile T2 Analyzer (or USB Mobile HS Analyzer)
• One 1-meter A-B cable (standard A plug to mini B plug)
• One 1-meter A-B cable (mini A plug to mini B plug)
• One 15-centimeter On-the-Go (OTG) adaptor
(standard
A receptacle to mini A plug)
• Installation CD
• USBMobile T2 Quick Start
Note : All USB Mobile T2 items also apply to USB Mobile HS.
2.19.1 Setup
Insert the USB Mobile T2 card (or USB Mobile HS card) into a PCMCIA slot on your host
computer.
Figure 2.14 USB Mobile T2 Setup
Note : The USB Mobile T2 (and USB Mobile HS) card does not fit into an ExpressCard slot.
To install components:
Step 1 Connect a host to one of the mini A-B receptacles (use an adaptor if
necessary), and connect your device to the other. It does not matter
which receptacle into which you plug.
Step 2 Insert the CD-ROM.
Step 3 Click NEXT when you see the Add New Hardware Wizard window.
Step 4 Follow the on-screen Plug and Play instructions.
Step 5 Click Finish when you see the message that says “Windows has
finished installing the software that your new hardware requires” and the
file
USBMobileT2.inf (or USBMobileHS.inf ) has been installed on your
host PC.
Note:
USB Mobile T2 (and USB Mobile HS) USB is not a hub device. It connects to a USB
branch by inserting a non-intrusive, high-impedance tap. Because poor signal quality in
the middle of a USB cable, LeCroy recommends using the shortest possible cables, so
that total length of both cables together is less than six feet. The USB cables provided
with your Analyzer meet this requirement. When longer cables are used, the Analyzer
might record incorrect data.