Nuts
Type C: Install Lamp on an Arm Pole
C1. Find two holes on both sides of the frame. Place two
nuts individually into the slots. Insert the screws
through the holes and secure the nuts (as shown in
the picture on the left).
C2. Inset the lamp base in the frame, and then insert the
arm pole into the lamp frame. Fasten the screws with
the Anti-theft Spanner (as shown in the picture on the
left).
Type D: Install with LEADSUN Optional Lamp Post.
D1. Insert the lamp pole into the bracket. Make sure to
match the holes on the lamp pole with the snap joints
on the base.
D2. Joint the three pins with the correct position of bracket,
and fix the pins by ST4
×
10mm (as shown by left
diagram)
D3. Fill the Water Base with water.
Place three Water Base unto the base pins to stabilize
the lamp post (as shown in the picture on the left).
EN
9
10
Caution:
The diameter of the Arm Pole is required to be
30~40mm, If beyond the diameter, please buy a
special converter port to install the lights.
Caution:
1. Fill the water base with cold water or sand as per
demand.
2. Add one spoon of Chlorine Bleach with cold water to
prevent the algae.
3. Make sure the cover is sealed well avoiding any
leaking.
4. The three Water Base must be used together, once
one is leaking, please stop using and contact seller
for replacement.
Cold Water