CS-D1008E Closed Loop Stepper Drive User Manual
Page | 18
Appendix B. Leadshine CS-D1008E Compatible Power Supplies
It is highly suggested to use the following Leadshine power supplies to power CS-D1008E to get optimized
performance. Those power supplies are specially designed for stepper and servo controls.
Appendix C. Powering a Third-Party Motor with CS-D1008E
It is highly recommended to choose a Leadshine closed stepper motor along with the CS-D1008E closed loop stepper
drive, for getting the best system performance and easy setup. See Appendix A for frequently purchased Leadshine
closed loop stepper motors.
For an OEM project if you can’t find one on Appendix A meeting your requirements there, contact Leadshine sales
directly by emailing
or
. Leadshine carry’s many other custom models
and there may be one there which can satisfy your application need already.
In the case of powering a third party closed loop stepper motor, pay special attention as described below.
Your stepper motor must be a 2-phase stepper motor
Your stepper motor must be mounted with a quadrature rotary encoder with the resolution of 500-5,000 line
(2,000- 20,000 CPR).
When the CS-D1008E is first-time powered on after your stepper motor is connected, check the following
possible causes if a position following error (see Section 9 above) happens.
o
Confirm both encoder and power cables are connected properly and tightly secured.
o
Power off the drive then swap the A+ and A- motor connections to the CS-D1008E drive. The reason is
the definitions of your Motor A+ and A- are different from those marked on CS-D1008E motor
connection pins (P4 of Figure 2).
If protection error is still seen after the above steps, contact your CS-D1008E drive supplier or Leadshine
technical support.